|
Many thanks for the reply. What sort of "high wear parts"
should I expect from the 200? I'm also running a custom
stepped header (1" to 1.250" to 1.50" collector) and
noticed your jetting. I appreciate
the openness to share performance insites. Was wanting to
flow around 80-85 percent exhaust to intake ratio, and feel there is
a lot of potential in the little engine. Thanks again for the reply.
By the way, what combinations of piston and connecting rod options
are available for it? Flycutting, decking the piston, re-ground cam, etc. isn't a problem.
|