Quote:
Originally Posted by Adjuster
Disassemble the switch. Should be an easy repair. Usually a piece of spring steel inside applying pressure to a ball bearing that clicks in and out of place for the detent. Be careful as there will be a spring under the ball bearing and you don't want to loose any of the small parts. Bend whatever you need to make the switch work better then smear it all with dielectric grease and you will never have a problem again.
Again be very careful of small parts under spring pressure.
/
|
Quote:
Originally Posted by NoVa Rider
Good suggestion on repairing the switch, Adjuster. I take it you checked yours and determined that it can't get stalled in a "dead" position? If that's the case, I may contact CSC about a new switch. It is supposed to be under warranty.
|
I repaired the headlight slider switch on my Zongshen RX3 switchgear. Here is a link to a thread which describes how I did it. 
http://www.chinariders.net/showthrea...457#post189457
__________________
Spud
"Never argue with an idiot. He will drag you down to his level, and beat you with experience." Mark Twain
2015 Zongshen ZS250GY-3 (RX3)
2006 Zongshen ZS200GY-2 (Sierra 200)
2005 Honda XR650L
2004 Honda CRF250X
1998 Kawasaki KDX220
Mods made to my Zongshen ZS200GY-2: http://www.chinariders.net/showthread.php?t=6894
|