[SpudRider]

The 2nd generation, CSC center stand fits easily inside the frame mounts. I did not need to trim the mounts.

I used my Tusk Spring Puller, instead of a screwdriver, to facilitate the installation of the spring.

https://www.rockymountainatvmc.com/p...+spring+puller



I hooked the free end of the spring on the Tusk spring puller. Using the Tusk tool as a lever, and the spring mount on the center stand as a fulcrum, I stretched the spring. Holding the spring in the stretched position with one hand, I inserted about 9 pennies between the coils of the spring with the other hand.

With the pennies holding the spring in a stretched position, I released the lever. I then used the Tusk tool to pull the spring onto the spring mount of the center stand. After the spring was installed, I removed the pennies.