ChinaRiders Forums - View Single Post

NeedInfo200 · 06-21-2022, 02:14 AM

I'm enjoying my scooter so far. It is smooth and quiet and fires right up on a cold start.

I have replaced the Variator weights with 14 gram Dr pulley sliders and replaced the chino gates belt with a Bando brand. What a difference no more slipping on acceleration.

Does anyone have the speedo calibration procedure? Also I get a check engine light after riding over 55mph for over a few minutes anyone else? Still runs fine and light goes off after a while. Sometimes I get a misfire at certain throttle positions around mid and full. I did replace the plug with a NGK but no difference.

Where do Clash 200 owners get service and technical information for these bikes?

Any info would help greatly!

06-21-2022, 02:14 AM	#44
NeedInfo200 Join Date: May 2022 Location: Southern California Posts: 25	Vitacchi Clash 200 Scooter I'm enjoying my scooter so far. It is smooth and quiet and fires right up on a cold start. I have replaced the Variator weights with 14 gram Dr pulley sliders and replaced the chino gates belt with a Bando brand. What a difference no more slipping on acceleration. Does anyone have the speedo calibration procedure? Also I get a check engine light after riding over 55mph for over a few minutes anyone else? Still runs fine and light goes off after a while. Sometimes I get a misfire at certain throttle positions around mid and full. I did replace the plug with a NGK but no difference. Where do Clash 200 owners get service and technical information for these bikes? Any info would help greatly!
	0