It was a gorgeous day in NE Illannoy. I got outside and went up and down the street on the knee scooter then ventured into the garage. I proceeded to get the lathe bolted to the bench. I will admit that what should have taken 15 minutes, maybe a half hour, with two good legs took me well over an hour to do. It did wear me out. Too many days on my butt the past 3 weeks and too many hours on the scooter today.
I ordered some .002 shim stock so I can set the bearing clearance on the head stock this week. Then get the new belts on, followed by whatever else is needed so I can start making chips. One tidbit I learned about the lathe, from 1932 thru 1935, the Atlas/Craftsman 9" lathe used babbit bearings on the head stock main shaft. From 1936 on, the main shaft ran on needle bearings. Mine runs on babbit, so pre 1936.
__________________
Cheesy
______________________________________
07 Hi Bird Enduro-Flown the Coop
07 Ural Gear Up
79 Honda CX500
77 VeloSolex 4600 V3
73 VeloSolex 3800
I'm making this up as I go.-Indiana Jones
Telling me something 'is for my own good', is a fast way to a fat lip.-Me
I don't even care about my own problems, why should I care about yours?-Quote on one of my favorite t-shirts
|