Main Loom into Lamp
Oviously the current electrical outlay is not exactly the same as what was originally on the 6volt XL185 setup.
If I vaguely recall I think the main loom used to enter the black service box under the lamp bucket and then connect and branch up into the lamp bucket...which was a bit strange...Honda had some quirks.
Trying to enter the back of the lamp bucket has literally hit a snag...
So I am going to shoot for the middle and enter the main loom into low entry point of the lamp bucket, however there is a bracket edge that might need some shaving to prevent the loom cutting itself with friction while turning.
Could I have had the roadworthy inspection as was and passed...perhaps.
But Also the inspector might pickup on such things and strike a fail...
|