ChinaRiders Forums - View Single Post

Bill Hilly · 12-13-2022, 09:38 PM

I ordered a flywheel puller from Amazon to use on my TBR7 when I do the engine mods. It is one of those with a 27mm end, and a 24mm end, and a bolt running through it .I knew that the 24mm, and 27mm piece would not be of any use, but I thought I had seen somewhere that the center bolt of the puller by itself could pull the flywheel. On the Facebook page someone asked about a puller, and evidently it takes a 16mm-1.5 thread bolt type puller. I measured the bolt from my puller, and it's 14 mm. Is it correct that it takes a 16mm? And can I just buy a bolt? , And if so how much if the shank needs to be threaded? Thanks

12-13-2022, 09:38 PM	#1
Bill Hilly Join Date: Feb 2021 Posts: 947	Bolt size to pull CG flywheel??? I ordered a flywheel puller from Amazon to use on my TBR7 when I do the engine mods. It is one of those with a 27mm end, and a 24mm end, and a bolt running through it .I knew that the 24mm, and 27mm piece would not be of any use, but I thought I had seen somewhere that the center bolt of the puller by itself could pull the flywheel. On the Facebook page someone asked about a puller, and evidently it takes a 16mm-1.5 thread bolt type puller. I measured the bolt from my puller, and it's 14 mm. Is it correct that it takes a 16mm? And can I just buy a bolt? , And if so how much if the shank needs to be threaded? Thanks
	0