|
You don't need an original part for brake lines. They're all mechanically the same.
Just measure the length of the thing, determine if there are any pre-bent angles in the metal parts on either end that need to remain the same, and verify that the fittings on the end are for 10mm banjo bolts (the overwhelming majority of them are) and just order whatever you can find that's close enough from whichever wretched hive of scum and villainy is available to you: Amazon, eBay, Aliexpress, local shop, whatever.
It's usually literally as easy as take the old one off, lay it out straight on the floor, and measure how long it is with a tape measure.
You'll probably want to replace the copper crush washers for both fittings on either end, as well. You'll need four. They cost pennies.
|