Admin Code
Any luck with the admin code? I will try messing with it later. Too hot out now 105.
I'm still experimenting with the temp probe resistance. It's been in the 90s here at night so I went on my full throttle run. In testing now I'm lowering the resistance of the pot to see at what point the ecm flags a engine check error.
If I set the pot at 1.2k ohms it runs great but, on a hot restart it acts as if "the choke is on" and stumbles a little. Which makes perfect sense. The ecm is fooled into thing it's a cold start. I lowered the pot to 300 ohms and it seemed to hot start OK. Testing further tonight.
|