Quote:
Originally Posted by 4T_Goblin
It was stock set at ~26mm, I set it to 21mm. Had the issue both times. I can try going higher to 30mm
|
From a post from Weldangrind:
"I would set the float level with the carb upside down and no pressure on the floats (other than gravity). The plastic parting line in the middle of the float should be parallel to the gasket surface.
I've had good luck setting them with this process. Thanks again Weldangrind wherever you are!
Thread with above quote. Lots of good carb info;
http://chinariders.net/showthread.ph...ng+float+level