|
Exsqueeze me
So Engine back out...
Couple of reasons...
1. I cant carry the whole assembly down stairs due to total weight and store in the garage where the Motorcycle will appropriately belong. the lounge room has served its project needs and I need to make way for wooden floor prep and sanding.
2. Assembling the bike completely and riding out of the house is not a wise move.
And 3. I had to shave some meat off the engine mount as it was to wide ti fit the bolt spacer and cable bracket as the Honda 163 engine allowed.
OHS moment when I plugged in the grinder with cutting disk only to have spin on and kick off the floor...disc disinterested, thankfully no harm done. Could have sworn it was switched off...but guess not. lost my only cutting disc though...Death wheel is an appropriate nomenclature. I was wearing my face shield.
Hard to revert to hacksaw with flappy sander finish.
the bike will be relocated to the garage.
Waiting for some 4 and 5 pin relays, Ordered an LED gear indicator module and figuring out a dash plate to hole the digi dash, ignition key and whatever else in future.
|