[Megadan]

Originally Posted by JerryHawk250

for anybody looking to port there head, I ran across this thread this morning. Very informational and with pictures. https://thumpertalk.com/forums/topic...onsiderations/

He did the same trick I did with the port floor around the short side radius on the intake. I widened that up on the right side of the port along the outer edge of the curve. That was the only real port shaping I did besides the port match at the flange.

As far as the thinner material around the guide. Where it is the thinnest doesn't really need much material removed anyway. Most of the material removal is at the bowl and especially next to the guides just leaving the bowl along the roof of the port right next to the guide.