Quote:
Originally Posted by JerryHawk250
No, Not unless someone decides to start doing it. I would and have done a couple but I don't think you would want to pay the price. lol It takes a good bit of time to port and deck a head. If someone had a CNC machine that was programmed to do it then it might be doable at a reasonable rate. Porting is not hard, just time consuming.
|
This is why I haven't done the head for other guys. To make it worth my while the bill would likely end up close to what a local professional race shop would charge, and they have the equipment to do proper seat grinds, etc.
I also think that even if a shop was located that could do a CNC program they would either require a minimum order to make it worth their time to write said program, or somebody would be paying a lot of money for one head. Then, assuming one was found that was reasonably affordable, it would still likely be more expensive than anybody here would want to spend, aka $400-500.