Quote:
Originally Posted by JerryHawk250
This is where someone with a 3D printer would come in handy to make a custom intake like the Nibbi but at the right angle.
|
I would take anything at this point lol. The intake I am now using works just fine. If everything was on the opposite side it would be perfect.
I am considering modifying the Nibbi intake a bit by cutting it down. I would lose the groove for the boot to sit in, but it should work fine without it. I could then make it as short as I want, and solve most of my problems.
If all else fails I am going to run a 32mm carb with a CRF intake.