Quote:
Originally Posted by rjmorel
So i got the 300 kit installed and am proceeding with putting all the rest of bike back together. Then i notice the intake manifold o ring was missing. Cant find it any where. Im assuming since it was almost directly over the crank case opening that it fell down onto the rag stuffed in the crankcase and when i pulled the rag out the o ring fell in.????????
So my question for all of you is can i see into the crankcase below the crank if i take the clutch side cover off to fish it out?
I definately dont want to pull head and cylinder off again and order new gaskets . Thanks rj
|
Sadly no you cant see anything, but I strongly suggest loking around the outside area cause I doubt you lost it in there.
Mind you a rubber O ring in crank area can't do much harm as it is cheing gum n just break up in to pieces and pulp