ChinaRiders Forums - View Single Post

wamey · 09-25-2018, 05:16 PM

I'm going to resurrect an old thread to ask about the Pod filters you guys are running. Did you make any changes to the jet sizes/needle position when changing from the airbox to the foam filter?

I'm thinking the following setup will work well but am concerned about melting my piston from a lean condition:

- UNI Pod filter (Oil wetted foam)
- Mikuni VM26 (110 main jet, 30 pilot jet, needle set to middle)
- Stock engine
- Stock exhaust

I'm at 900' elevation. Thanks for any help you can offer, I'm sifting through all the threads that come when searching for "pod filter"...

09-25-2018, 05:16 PM	#5
wamey Join Date: Jun 2017 Location: Madison, WI Posts: 96	I'm going to resurrect an old thread to ask about the Pod filters you guys are running. Did you make any changes to the jet sizes/needle position when changing from the airbox to the foam filter? I'm thinking the following setup will work well but am concerned about melting my piston from a lean condition: - UNI Pod filter (Oil wetted foam) - Mikuni VM26 (110 main jet, 30 pilot jet, needle set to middle) - Stock engine - Stock exhaust I'm at 900' elevation. Thanks for any help you can offer, I'm sifting through all the threads that come when searching for "pod filter"...
	0