Cylinder Head Intall!s
I decided to take my mind off of wiring for a little bit and tackled installing my ported head.
After I got it all back together and spun it over slowly to make sure nothing bad was going to happen I installed my new spark plug and decided to give it a good kick or two. She definitely is a lot harder to kick over than my last one! Still not super hard, but it is definitely a noticeable increase in pressure.
I did a leakdown test to make sure all was good and sealed as well and she is good to go! I can't wait to start her up now. Just the motivation I needed to finish up. I also added this post to my resource guide under DIY/How-To so hopefully other people will find it helpful.
|