ChinaRiders Forums - View Single Post - Hawk 250 Custom-ish

richinar · 12-05-2017, 02:46 PM

Thanks for the kudos

Hard to put things aside and move on

Probably going to go with a tracker-inspired back end and seat.

Put the MSR shifter on but didn’t like the clamp’s clearance so have chopped it off, trimmed its length a little and welded onto the stock clamp.

The fender slides into the frame between the sheet metal bracketry and tubes to fit extremely snug.

I’ll probably rebuild the battery box with a slope towards the rear to house the electronics in a foam-lining and deter the vibration which is likely imparted by having the ECM and flasher zipped onto the frame. I took out the sheet steel cross-brace under the seat and put in a tube.

12-05-2017, 02:46 PM	#10
richinar Join Date: Nov 2017 Location: Little Rock Posts: 27	Thanks for the kudos Hard to put things aside and move on Probably going to go with a tracker-inspired back end and seat. Put the MSR shifter on but didn’t like the clamp’s clearance so have chopped it off, trimmed its length a little and welded onto the stock clamp. The fender slides into the frame between the sheet metal bracketry and tubes to fit extremely snug. I’ll probably rebuild the battery box with a slope towards the rear to house the electronics in a foam-lining and deter the vibration which is likely imparted by having the ECM and flasher zipped onto the frame. I took out the sheet steel cross-brace under the seat and put in a tube.
	0