|
Problem solved guys and you wouldnt believe what it was. It wasnt the battery and was nothing you guys would ever guess. After a few calls to Bruce @ EJCycles, he and I poured over almost every possible cause and couldnt come up with anything. BTW if you guys ever need technical support Bruce is the man...and I do mean the man! Ok back to the solution, I went over the schematic over and over to the point of memorizing it. I took out my Fluke and started checking for power at every plug, and low and behold...ALL THE HOTS WERE GROUND AND ALL GROUNDS WERE HOT! Every plug was wired for reverse polarity. After switching the pins on every plug I got all the electrical problems solved except for the starter...I pulled the ignition and it was the same way. As I turned the key it reversed polarity to the starter causing it to turn backwards free spinning the sprag (if you know how a sprag works you'll know what Im talking about). Thus not engaging the engine. Some of you guys are thinking why didnt I just switch the leads on the battery...Well if you look on the schematic, you will see that you have a rectifier and diodes, reversing the leads would have fixed only 25% of the electrical problems except for the components connected to the rectifier and diodes. I mentioned a sprag earlier, for the ones who havent seen one, what that is, is a one clutch or one way bearing. It will free spin in one direction and grab in the other. This is how your starter cranks the engine, once your enging is started, centrifical force disengages the sprag not allowing the engine to spin the starter. The sprag is an actual bearing and not a true clutch, clutches usually comprise of springs, drum, disk or some kind of friction material. A sprag is an actual roller bearing(s) and is located on the back side of the flywheel, it has frictional material on the faces of the cage to allow lock up, theres is also a housing that the sprag sits in and has detents which keeps the bearings free spinning in one direction. This housing is attached to the flywheel and provides the centrifical force to seperate the sprag thus keeping the friction material from burning up. My bros GY-5 is a grey Lifan which he bought from the internet, compared to my American Lifan the 2 bikes are identical but once you remove the fairings the grey Lifan is a totally different animal. Quality is not even close to the American Lifan, the frame is different, the wiring harness is different as well as a few other items. There nothing on the bike that is stamped with LF, American Lifan stamps just about every single part with LF even the heads of the bolts. Learn a lesson from this nightmare and DONT BUY A GRAY LIFAN! Get yourself an American Lifan from a respectable dealer like Bruce @ EJCycles. Thank you guys so very much for the input.
|