Ok I finally got some time to pull the carb and replace the bottom screws and the air fuel mixture screw.
The Pilot/Low jet installed is a 34.
The Main Jet is a 105
The pilot jets for this carb are 13 mm long and they are available here
https://www.aliexpress.com/item/New-...6-c00df13f6d79
I put in a 108 Main Jet up one from the stock 105
I put in the new needle and put the clip in the 4th down position I wanted it to be similar to what I had before.
I put in the new screws in the bottom and the new Air Fuel Adjustment screw.
It still is a major PITA adjusting this who the f would put it in such an awful place.
I am going to see if I can find a flexible screw driver shaft.
Ordered this
https://www.aliexpress.com/item-img/...00017.4.HHiJs8
I definitely need the pilot / low speed jets I have to adjust it out around 3 turns to get a good idle and starting.
The top end is better with the one jet bigger when you crack the throttle much more responsive.
So I am going to order those jets and see what I come up with.
Hope this helps someone else.