I have a couple of questions for those who've swapped out their clutch and brake lever assemblies.
My goal is to get adjustable reach, folding and a bit shorter.
I'm looking at this set:
http://www.ebay.com/itm/121831131454...%3AMEBIDX%3AIT
They are for a 7/8"/22mm bar which my 2016 RX3 has.
They have 10mm bolt threads for mirrors which matches the RX3. Hoping it's the same pitch!
They have a 10mm hole for the clutch cable ferrel to slide into and I measured mine and it's 9mm and the ferrel itself is 8mm. Should be fine with a little slop...It has some now anyway.
It has a 10mm connection for the brake Banjo.
Other measurements are in the pictures on the link.
1 - Is a 10mm brake banjo correct for the RX3?
2 - All brake banjo's I've seen others speak about also have the brake banjo connector coming out the side instead of the front. What have others done to resolve the positioning? See below for pic of this new lever and the stock RX3 to compare?
3 - Any other questions, comments or concerns you may have with this selection?
Thanks so much for the help!