ChinaRiders Forums - View Single Post - Adding brake lights with 4-wire turn signals

detours · 06-04-2016, 04:58 PM

Prep the second triple connector for the brake lights.

Cut 2-4 inches of 16 gauge wire.
Strip 1/4 inch off one end and twist the wires.
Lay the stripped end into clamp of the triple connector.
Use your electrical pliers to clamp around the wire. The large clamp goes around the plastic insulation. The small clamp goes around the bare wire.
Be sure the connection is tight.

06-04-2016, 04:58 PM	#5
detours Join Date: Sep 2014 Location: Arvada, CO Posts: 1,004	Step 5: Prep the second triple connector Prep the second triple connector for the brake lights. Cut 2-4 inches of 16 gauge wire. Strip 1/4 inch off one end and twist the wires. Lay the stripped end into clamp of the triple connector. Use your electrical pliers to clamp around the wire. The large clamp goes around the plastic insulation. The small clamp goes around the bare wire. Be sure the connection is tight. Attached Images __________________ Red 5 standing by! 2015 CSC red RX3 with 19" front wheel, Shinko 804/805, skid plate, tall seat, 13T/45T sprockets, progressive shock, Winyoochanok windshield, GENSSI LED headlight, SW-Motech tankbag, Shorai Lithium battery 2014 Ural Patrol Last edited by detours; 06-06-2016 at 08:42 PM.
	0