ChinaRiders Forums - View Single Post

NoVa Rider · 05-01-2016, 05:24 PM

I drilled three holes to line up with the threaded holes in the RX3 carrier. The two forward holes in the GP plate are just outside and to the front of the two forward slots, The center of the rear hole is 21mm forward of the front edge of the latch doohicky. The plate fit perfectly over the RX3 carrier. I put a number of wide plastic washers I had between the GP plate and the RX3 carrier to lift the plate up a bit so the slot edges would be squished. And I put some marine adhesive under the four rubber bumper on the GP plate so they would not fall off.

05-01-2016, 05:24 PM	#2
NoVa Rider Join Date: Jan 2015 Location: Northern Virginia Posts: 144	I drilled three holes to line up with the threaded holes in the RX3 carrier. The two forward holes in the GP plate are just outside and to the front of the two forward slots, The center of the rear hole is 21mm forward of the front edge of the latch doohicky. The plate fit perfectly over the RX3 carrier. I put a number of wide plastic washers I had between the GP plate and the RX3 carrier to lift the plate up a bit so the slot edges would be squished. And I put some marine adhesive under the four rubber bumper on the GP plate so they would not fall off.
	1