The 2nd generation, CSC center stand fits
easily inside the frame mounts. I did
not need to trim the mounts.
I used my Tusk Spring Puller, instead of a screwdriver, to facilitate the installation of the spring.
https://www.rockymountainatvmc.com/p...+spring+puller
I hooked the free end of the spring on the Tusk spring puller. Using the Tusk tool as a lever, and the spring mount on the center stand as a fulcrum, I stretched the spring. Holding the spring in the stretched position with one hand, I inserted about 9 pennies between the coils of the spring with the other hand.
With the pennies holding the spring in a stretched position, I released the lever. I then used the Tusk tool to pull the spring onto the spring mount of the center stand. After the spring was installed, I removed the pennies.
__________________
Spud
"Never argue with an idiot. He will drag you down to his level, and beat you with experience."
Mark Twain
2015 Zongshen ZS250GY-3 (RX3)
2006 Zongshen ZS200GY-2 (Sierra 200)
2005 Honda XR650L
2004 Honda CRF250X
1998 Kawasaki KDX220
Mods made to my Zongshen ZS200GY-2:
http://www.chinariders.net/showthread.php?t=6894