Quote:
Originally Posted by Adjuster
Looks like that wiring harness is supposed to be inside the bracket...
|
Quote:
Originally Posted by Jay In Milpitas
.... Might want to zip tie the harness to the frame to reduce chaffing between filter cleanings, though.
|
Quote:
Originally Posted by SpudRider
.... The wiring harness should be routed above the air box cover, following the outside edge of the frame.
I suggest you might remove one inch from the end of the strap..... You can then route the wiring harness through the loop, and the wiring harness will be above the air box cover.  .......
You should support the rest of the wiring harness with zip ties. Of course, you can remove the bracket entirely, and support the entire wiring harness with zip ties. |
Thanks for the responses.
I had previously put the wiring harness in the bracket, but was worried that with constant vibration, it might wear through the harness covering, so I removed it.
This was the
stock routing of the harness:
And this is after I put the harness in the bracket (it was a tight fit, had to bend the bracket...that may have caused the screw to be blocked even more):
I'm leaning towards removing the bracket completely.
BTW, there is an identical bracket on the opposite side of the frame.
jb