Adjusting the brake pedal height wasn't obvious to me, but it turned out to be pretty simple. (Maybe I should have read the manual
)
- Follow the brake pedal back to the rubber boot under the rear brake reservoir.
- Carefully pull the rubber boot up from the bottom to expose the lock nut.
- Using a 10mm open-ended wrench, loosen the lock nut. Leave plenty of room.
- Grasping the rubber boot, turn the entire bolt by hand. It will move easily and adjust the brake pedal up or down.
- At the desired height, tighten the locknut
- Carefully pull the boot down over the locknut. Make sure the top of the boot stays in its groove and maintains a good seal.