ChinaRiders Forums - View Single Post - Clutch not disengaging for Zongshen ZS200GY-A

culcune · 08-30-2014, 01:43 PM

This is where I lost the use of my '09 TMEC and bought the '13 model back in May. I think I was having clutch issues, but the other problem was the fact that my engine was welded to the frame, so not sure if it was cable length issues instead.

Worse case scenario, Zonganaut, if you cannot find clutch plates easily, how difficult would it be to find a replacement engine in NZ? Depending on what part of the country you are in here in the US, or if you have connections to a distributor

, these bikes are a dime a dozen. What is the market there?

08-30-2014, 01:43 PM	#12
culcune Join Date: May 2006 Location: Yuma, Arizona Posts: 9,035	This is where I lost the use of my '09 TMEC and bought the '13 model back in May. I think I was having clutch issues, but the other problem was the fact that my engine was welded to the frame, so not sure if it was cable length issues instead. Worse case scenario, Zonganaut, if you cannot find clutch plates easily, how difficult would it be to find a replacement engine in NZ? Depending on what part of the country you are in here in the US, or if you have connections to a distributor , these bikes are a dime a dozen. What is the market there? __________________ "They say that life's a carousel, spinning fast you got to ride it well..." TGB Delivery Scooter 150 TMEC 200 Enduro--carcass is sadly rotting in the backyard
	0