ChinaRiders Forums - View Single Post - Clutch not disengaging for Zongshen ZS200GY-A

humanbeing · 08-28-2014, 06:31 PM

Wear limit of "fraction": 2.6mm
There's 2 type in these pushrod machine:
Ref to VP-1019 http://catalog.vesrah.co.jp/list/street_clutch.asp

From memory "std" 200 uses the upper (7 fraction/ 6 metal).
---
In most case change "fraction" ONLY will get the job done.
FRACTION
http://item.taobao.com/item.htm?id=39176366379
METAL
http://item.taobao.com/item.htm?id=39478351810
ASSEMBLY
http://item.taobao.com/item.htm?id=39837275401
---
http://www.mychinamoto.com/forums/showthread.php?6812 had some tips about changing plates.
Non std method saving 100 000+km old bike:
http://www.motorfans.com.cn/forum.ph...authorid=75082

08-28-2014, 06:31 PM	#2
humanbeing Join Date: Mar 2008 Posts: 2,436	Wear limit of "fraction": 2.6mm There's 2 type in these pushrod machine: Ref to VP-1019 http://catalog.vesrah.co.jp/list/street_clutch.asp From memory "std" 200 uses the upper (7 fraction/ 6 metal). --- In most case change "fraction" ONLY will get the job done. FRACTION http://item.taobao.com/item.htm?id=39176366379 METAL http://item.taobao.com/item.htm?id=39478351810 ASSEMBLY http://item.taobao.com/item.htm?id=39837275401 --- http://www.mychinamoto.com/forums/showthread.php?6812 had some tips about changing plates. Non std method saving 100 000+km old bike: http://www.motorfans.com.cn/forum.ph...authorid=75082 __________________ Last edited by humanbeing; 04-06-2018 at 06:04 AM.
	1