i had planned on getting forks done today... but dagone it was cold today! i did get something done though. i got forks off in preparation to change seals..
but seeing as i had easy access to engine i decided to get valves adjusted..
everything up there looked like brand new! and valves were still in spec. i did adjust the intakes slightly to get em to .005 as the .005 was tight but i am sure a .004 would have fit perfect. i didn't bother grabbin a .004 gauge as i just set em to loose end of spec.
the inside of valve cover didn't even need cleaning.. just wiped off mating surfaces and put cover back on.
after installing valve cover i also finished installing front brake after rebuild and bled again and it is good to go.
getting closer....