Quote:
Originally Posted by david3921
Ok, getting the float to spec using the two manuals available was an adventure because neither is quite right. The english version shows the correct way to check it (setting the carb upside down) but gives the wrong spec. (30.5 mm). The Qingqi manual gives the correct spec (18.5 mm) but shows the wrong way to check it (on it's side).
I used Weldandgrind's method; upside down and align the seam in the floats, parrallel with the top of the float bowl. When I did this, the measurement was 18.5 mm and all is well.
Thanks Weld!
|
I'm glad it worked for you. My method is entirely blind luck. I started that way to establish a baseline with unknown carbs, and it worked well enough to not mess with it.