Quote:
Originally Posted by 2010limited
Ok so installed the jets, and it seemed to run good, except there was def still a vac leak. After using the wd40 method, I found that the intake tube was actually cracked, which is what caused the original gasket to tear.
So I dremeled it out a bit, and filled it with jb weld.
The machine seems to run ok, still have to tune up the settings on the carb as it seems to idle high, then if you leave it drop down after a second.
The mikuni made an amazing difference with starting though, the machine barely turns over.
|
Glad to hear that the Mikuni is an improvement, and that you found the leak source. If it still doesn't return to idle immediately, perhaps it's time for a new intake tube.