I jumped into this project for my girlfriend to ride about two months ago. I have a crf230m that I use to commute on and she is tired of the low speed of the metropolitan, but she is vertically challenged (4'11', 95 pounds) so bigger bikes are out. So i start with an old crf100 rolling chassis that my cousin had, and a banged up unknown zongshen bike that was totalled, but had a good riunning engine and ended up with this.
But i am at a stand-still on the wiring. There is a gear position indicator directly in front of the counter sprocket that the wires were cut going to it, and I cant figure out where they go in the wiring harness. Anyone have a diagram for just what it takes for the engine to run.? I can handle wiring the lights and switches on my own, i just need this thing to start like it is supposed to....