ChinaRiders Forums - View Single Post

FLASHLIGHTBOY · 02-19-2011, 05:42 PM

On a lot of the GIO bikes the fuel hose under the seat gets pinched off .. cheap rubber I always install the good clear plastic line.. and I even check when I put the seat on to make sure it is routed away from the pinch area... this is the main problem... it everyone would keep the problem small before the RIP off the carb and go into a main rebuilding situation then it would not seem so bad of a problem.. alot of people when they assemble their own bikes ( out of the crate..) They always forget to unkink the air breather line from the rear of the motor ( vent tube) this will pressurize the motor and blow oil out of the left side crank seal... I have had several buyers call up with that problem... when I tell them to check that.. they never call back... too embrassed..

02-19-2011, 05:42 PM	#35
FLASHLIGHTBOY Join Date: May 2009 Location: SASKATOON Posts: 1,161	250 DIRT BIKE STALLING On a lot of the GIO bikes the fuel hose under the seat gets pinched off .. cheap rubber I always install the good clear plastic line.. and I even check when I put the seat on to make sure it is routed away from the pinch area... this is the main problem... it everyone would keep the problem small before the RIP off the carb and go into a main rebuilding situation then it would not seem so bad of a problem.. alot of people when they assemble their own bikes ( out of the crate..) They always forget to unkink the air breather line from the rear of the motor ( vent tube) this will pressurize the motor and blow oil out of the left side crank seal... I have had several buyers call up with that problem... when I tell them to check that.. they never call back... too embrassed..
	0