Go Back   ChinaRiders Forums > Search Forums
Register FAQ Community Calendar Today's Posts Search
Showing results 1 to 25 of 25
Search took 0.01 seconds.
Search: Posts Made By: NeedInfo200
Forum: Pit/Pocket Bikes & Scooters 08-15-2022, 02:18 AM
Replies: 178
Views: 45,470
Posted By NeedInfo200
I figured the Odo would be off just like the...

I figured the Odo would be off just like the Speedo. I was messing with various 3 digit codes to try and get into setup but, no luck. Have you tried any Pass codes? The manufacturer sure isn't at all...
Forum: Pit/Pocket Bikes & Scooters 07-26-2022, 09:36 PM
Replies: 178
Views: 45,470
Posted By NeedInfo200
My knees hit the wind guard unless I move back to...

My knees hit the wind guard unless I move back to about the middle of the seat. Then I slide forward a little after each stop. Oh Well!
Forum: Pit/Pocket Bikes & Scooters 07-26-2022, 06:52 PM
Replies: 178
Views: 45,470
Posted By NeedInfo200
What octane are you running in your Clash? I've...

What octane are you running in your Clash? I've been using 91 and fires right up. I don't think it has extraordinarily high compression so maybe 89 will work. Either way it's great to fill it up for...
Forum: Pit/Pocket Bikes & Scooters 07-25-2022, 07:47 PM
Replies: 178
Views: 45,470
Posted By NeedInfo200
It's almost impossible to find any K block GY6 or...

It's almost impossible to find any K block GY6 or GY7 (whatever it is) parts. I suppose the main wear items will be in the top end and I have seen those at a few places online. A standard GY6 61mm...
Forum: Pit/Pocket Bikes & Scooters 07-24-2022, 03:32 AM
Replies: 178
Views: 45,470
Posted By NeedInfo200
I installed a 150 ohm resister in series with the...

I installed a 150 ohm resister in series with the thermister and no check engine light in 85-90 degree weather. I have 300 miles on it now and ready for the first oil change. I really like this...
Forum: Pit/Pocket Bikes & Scooters 07-02-2022, 08:37 PM
Replies: 37
Views: 5,256
Posted By NeedInfo200
therm resistance

Looks about the same as what I got on my readings. I ordered some metal oxide 1watt 1% 150 ohm resisters. I didn't measure current flow while power is applied but I think 1 watt is more than enough....
Forum: Pit/Pocket Bikes & Scooters 07-02-2022, 01:20 AM
Replies: 37
Views: 5,256
Posted By NeedInfo200
Speedo/Odo Accuracy

I noticed my speedo is off by about +4 or +5 mph after 40 mph. I haven't checked the odometer accuracy yet with my phone and GPS. I suspect it is off also.

They sure don't do much setup on these...
Forum: Pit/Pocket Bikes & Scooters 06-30-2022, 12:02 AM
Replies: 37
Views: 5,256
Posted By NeedInfo200
Temp resister value

I'm going to run it at 300 ohms for some time. I'll check hot and cold starts so I'm going to leave the pot in there for now. If a 100 or 500 ohm precision 1% resister in series with the thermister...
Forum: Pit/Pocket Bikes & Scooters 06-29-2022, 05:28 PM
Replies: 37
Views: 5,256
Posted By NeedInfo200
Lean machine

I agree with you about it running lean. But by fooling the temp sensor it seems to have full range pep. The missing has gone away and the hot start has been cured by lowering the the potentiometer to...
Forum: Pit/Pocket Bikes & Scooters 06-29-2022, 12:41 AM
Replies: 37
Views: 5,256
Posted By NeedInfo200
Head Scratching Thermister issue?

Looks like your on the same page as I am with this.



That's why I installed the pot in place of the thermister so I can see what parameters the ecm is looking for in both cold and hot running...
Forum: Pit/Pocket Bikes & Scooters 06-28-2022, 06:36 PM
Replies: 37
Views: 5,256
Posted By NeedInfo200
Well in a sense it's a standard thermister. But...

Well in a sense it's a standard thermister. But the range it should have for the ecm is unknown.

The pot i installed is providing a false reading to the ecm in hopes of finding the correct range...
Forum: Pit/Pocket Bikes & Scooters 06-28-2022, 06:01 PM
Replies: 37
Views: 5,256
Posted By NeedInfo200
Admin Code

Any luck with the admin code? I will try messing with it later. Too hot out now 105.



I'm still experimenting with the temp probe resistance. It's been in the 90s here at night so I went on my...
Forum: Pit/Pocket Bikes & Scooters 06-28-2022, 01:38 AM
Replies: 178
Views: 45,470
Posted By NeedInfo200
Just clicked over 200 miles and 2 1/2 tanks of...

Just clicked over 200 miles and 2 1/2 tanks of gas. Seems to be running better as it breaks in. I'm using full throttle now on short bursts and I've had it up to about 62mph on straight and level...
Forum: Pit/Pocket Bikes & Scooters 06-27-2022, 06:22 PM
Replies: 23
Views: 5,420
Posted By NeedInfo200
Vitacchi Clash 200 Scooter

I've been searching the internet for any technical info on this scooter. And I've found that it's a Honda Click 150i clone that Honda sells in Thailand, Philippines, Viet Nam, but not in USA. There...
Forum: Pit/Pocket Bikes & Scooters 06-27-2022, 06:12 PM
Replies: 37
Views: 5,256
Posted By NeedInfo200
PAS code?

I noticed the PAS code also. Must be a way to get into the speedo for changing some settings. I'll try a few pass-codes to see if I can get in. Ie. 0000, 1234, etc.



I haven't had the check...
Forum: Pit/Pocket Bikes & Scooters 06-26-2022, 06:12 PM
Replies: 37
Views: 5,256
Posted By NeedInfo200
Zero Valve Clearance?

I thought the same thing at first, but I can hear valve clatter so it has clearance.


What I did find is that the genuineness at Lifan used a temp sensor for a water cooled engine and not air...
Forum: Pit/Pocket Bikes & Scooters 06-26-2022, 06:36 AM
Replies: 37
Views: 5,256
Posted By NeedInfo200
Check Engine On

It doesn't blink but, comes on after high speed running. Then it goes off again. I notice a misfire when it warms up also.

I may have found a solution for it. I am running some tests now SFSG.
Forum: Pit/Pocket Bikes & Scooters 06-26-2022, 06:32 AM
Replies: 37
Views: 5,256
Posted By NeedInfo200
Lifan Manual

Thanks for the Lifan Manual link. I read through it and it speaks of an idle gulp valve with an adjusting screw. My efi doesn't have a adjusting screw on the air gulp but there is a adjusting screw...
Forum: Pit/Pocket Bikes & Scooters 06-23-2022, 01:25 AM
Replies: 178
Views: 45,470
Posted By NeedInfo200
Calibration/Missfire

I'm in California and I have a 2021 model GT1. Probably has different EFI ecm software. I may have figured out the check engine light and misfire issue. Still doing run check and so far no issues.
Forum: New Member Introductions 06-21-2022, 03:48 PM
Replies: 7
Views: 815
Posted By NeedInfo200
Clash 200 oil blow by

If the oil level is too high it will blow by the crankcase vent on top of the valve cover. I've seen several wrong ways to check the oil. Here's the right way. Place on center stand and level....
Forum: Pit/Pocket Bikes & Scooters 06-21-2022, 01:22 PM
Replies: 37
Views: 5,256
Posted By NeedInfo200
Thumbs Up Manual /Code Reader

Forgot to mention that I picked up a cheap code reader off Amazon $12. It plugs in under the front cover and does read out some basic engine stats. I have to play around a little more and see if I...
Forum: Pit/Pocket Bikes & Scooters 06-21-2022, 01:15 PM
Replies: 37
Views: 5,256
Posted By NeedInfo200
Owners manual

Maybe you got the actual Vitacchi Clash 200 manual? I got a very generic cover all models manual that is useless IMHO.


Can you post a copy of the manual you got with your Clash 200?
Forum: Pit/Pocket Bikes & Scooters 06-21-2022, 02:21 AM
Replies: 178
Views: 45,470
Posted By NeedInfo200
Belt size for Clash 200

I just replaced my belt (Gates China) with a Bando kevlar size 842/20/30.
I bought2 and I'll sell the extra for $20 including shipping if you are in the USA. Don't buy the cheap $10 or $15 Chinese...
Forum: Pit/Pocket Bikes & Scooters 06-21-2022, 02:14 AM
Replies: 178
Views: 45,470
Posted By NeedInfo200
Vitacchi Clash 200 Scooter

I'm enjoying my scooter so far. It is smooth and quiet and fires right up on a cold start.


I have replaced the Variator weights with 14 gram Dr pulley sliders and replaced the chino gates belt...
Forum: Pit/Pocket Bikes & Scooters 05-18-2022, 04:16 PM
Replies: 37
Views: 5,256
Posted By NeedInfo200
Vitacchi Clash 200

:hi:Just received my Clash 200 scooter and it's great! But the check engine light comes on/off. Saferwarehouse is no help for technical issues.



Does anyone know how to set the idle speed on...
Showing results 1 to 25 of 25

 
Forum Jump

All times are GMT -4. The time now is 05:36 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.