Go Back   ChinaRiders Forums > Search Forums
Register FAQ Community Calendar Today's Posts Search
Showing results 1 to 7 of 7
Search took 0.00 seconds.
Search: Posts Made By: Boxnix
Forum: ATVs 11-02-2023, 11:09 AM
Replies: 7
Views: 1,193
Posted By Boxnix
I keep wondering that, but ya I'm putting some...

I keep wondering that, but ya I'm putting some ass on it for sure. I work on a lot of 150cc engines and never had an issue with this. Next step is to yank the head and see what's going on. I was just...
Forum: ATVs 11-01-2023, 11:36 PM
Replies: 7
Views: 1,193
Posted By Boxnix
10-4, engine was cold. It starts fine until it...

10-4, engine was cold. It starts fine until it gets cold. Then I have to set the valves again.
Forum: ATVs 11-01-2023, 09:57 PM
Replies: 7
Views: 1,193
Posted By Boxnix
250cc valve lash not holding

I have been working on an RPS Tornado 250. Motor would not start because the valves were so tight. No biggy, lashed the valves. Started right up. The next morning it won't start. Valves are locked...
Forum: ATVs 10-26-2023, 06:42 PM
Replies: 3
Views: 963
Posted By Boxnix
Ya I tested it. I realized after I forgot to hold...

Ya I tested it. I realized after I forgot to hold the throttle open but even still it was enough it should chug. And it was an electrical issue that caused it to get parked for a year so I'm assuming...
Forum: ATVs 10-25-2023, 05:08 PM
Replies: 3
Views: 963
Posted By Boxnix
Head Scratching RPS Tornado 250. Have spark, comp, gas... Nothing

I'm getting my butt properly kicked on a 250 ATV that sat for a year. After replacing just about the whole electrical system (stator, CDI, coil, plug) I finally have spark. Replaced the carb with a...
Forum: ATVs 07-25-2023, 10:43 PM
Replies: 1
Views: 1,015
Posted By Boxnix
Coleman 125 ATV extra wire on cdi

Anyone know what the deal is with the extra wire coming out of this CDI? The wire is green and is attached to the reverse indicator wire. It is not shorted to ground. I think the CDI is bad but the...
Forum: Pit/Pocket Bikes & Scooters 05-19-2023, 02:06 PM
Replies: 2
Views: 864
Posted By Boxnix
Head Scratching Looking for 6mm M6 head bolts for 110

I'm working on a 110cc (152FMH) motor I am rebuilding for a customer. I snapped off one of the head bolts and I'm struggling to find a replacement. Everything out there has M6 threads on the engine...
Showing results 1 to 7 of 7

 
Forum Jump

All times are GMT -4. The time now is 09:17 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.