Go Back   ChinaRiders Forums > Search Forums
Reload this Page Search Results
Register FAQ Community Calendar Today's Posts Search
Showing results 1 to 14 of 14
Search took 0.00 seconds. Search: Posts Made By: l00ker
Forum: ATVs 12-03-2009, 10:56 PM
Replies: 51
Views: 57,267
Posted By l00ker
ATV is now running! A good carb cleaning did the...

ATV is now running! A good carb cleaning did the trick. Still needs a little adjstment, but runs OK.
I double checked the spark and I am unclear exactly wich wire was loose. I checked EVERYTHING...
Forum: ATVs 12-03-2009, 03:01 PM
Replies: 51
Views: 57,267
Posted By l00ker
I am going out now to pull the carb apart to give...

I am going out now to pull the carb apart to give it a good cleaning. I will double check and tell everyone the specific wire that was causing the no spark. I will post my findings tonight.
Again...
Forum: ATVs 12-01-2009, 10:23 AM
Replies: 51
Views: 57,267
Posted By l00ker
Thanks for all your help ... been busy with the...

Thanks for all your help ... been busy with the holidays. ATV is still not running, but I am a little closer. I am now getting spark! Turns out it was a connection at the rectifier. Now I am not...
Forum: ATVs 11-23-2009, 09:04 PM
Replies: 51
Views: 57,267
Posted By l00ker
Thanks for the input. The rectifier is the ONLY...

Thanks for the input. The rectifier is the ONLY thing that I have not looked at. Yes, When I put the new coil on it came with all new wires including the plug wire. I will look at the rectifier...
Forum: ATVs 11-23-2009, 02:39 PM
Replies: 51
Views: 57,267
Posted By l00ker
I do not know the specific model. It is...

I do not know the specific model. It is identical to the Roketa, Tao-Tao, or the Gio mini 110cc. They are all the same.
Forum: ATVs 11-23-2009, 12:41 PM
Replies: 51
Views: 57,267
Posted By l00ker
No alarm / remote kill.

No alarm / remote kill.
Forum: ATVs 11-23-2009, 12:19 PM
Replies: 51
Views: 57,267
Posted By l00ker
Kill switch is fine. Took it apart and found no...

Kill switch is fine. Took it apart and found no problems.
I am measuring .1 volts AC on the timing trigger
I am now measuring 55 volts AC on the ignition power pin (I am assuming it is dropping...
Forum: ATVs 11-21-2009, 11:06 AM
Replies: 51
Views: 57,267
Posted By l00ker
Thanks for the help ... I will try this afternoon...

Thanks for the help ... I will try this afternoon and let you know!
Forum: ATVs 11-20-2009, 07:37 PM
Replies: 51
Views: 57,267
Posted By l00ker
OK here is the update. My CDI does look like the...

OK here is the update. My CDI does look like the picture. I tested the kill switch pin and it reads infinite ohms as it should. It is not a kill switch problem. The power supply to the CDI from...
Forum: ATVs 11-19-2009, 11:31 PM
Replies: 51
Views: 57,267
Posted By l00ker
- It is a used quad not new - it is the on/off...

- It is a used quad not new
- it is the on/off toggle switch on the handle bar
- Yes, plug is making good contact on the boot. As mentioned earlier it is a new coil with a new wire going to the...
Forum: ATVs 11-19-2009, 08:57 PM
Replies: 51
Views: 57,267
Posted By l00ker
Brake light does come on. Correct me if I am...

Brake light does come on. Correct me if I am wrong but the only saftey switches that will cause no spark is the rear tether and the key ignition switch and the handlebar kill switch.
The brake...
Forum: ATVs 11-19-2009, 08:32 PM
Replies: 51
Views: 57,267
Posted By l00ker
Correct brake is set. I have traced EVERYTHING...

Correct brake is set. I have traced EVERYTHING and cannot get spark. I even replaced the tether kill switch in the back with a brand new one. Still no spark. I am lost .... Any other suggestions...
Forum: ATVs 11-19-2009, 07:54 PM
Replies: 51
Views: 57,267
Posted By l00ker
Which ones in particular should I be paying...

Which ones in particular should I be paying attention too? Is there any one that is worse than the other?
Forum: ATVs 11-19-2009, 07:35 PM
Replies: 51
Views: 57,267
Posted By l00ker
No spark on 110cc mini atv

I have no spark and can NOT figure it out. I have checked and replaced everything. I have replaced the CDI and the ignition coil and spark plug. I checked and made sure I was getting voltage out...
Showing results 1 to 14 of 14

 
Forum Jump

All times are GMT -4. The time now is 04:19 AM.

Contact Us - ChinaRiders.net - Archive - Top

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.