Cg250 Flywheel threads.
I have been searching for a while to find this answer with not much luck. I need the thread size for the flywheel puller. From what I could find I believe it is an M27 left hand thread, but if anybody can tell me for sure I would appreciate it.
|
|
Ok, so it is an M27x1. I will order this puller as it appears to be the same as what you linked. https://www.ebay.com/itm/1pc-Black-M...-/352663054759 Thanks for the response!
|
I have that tool used it on CB engine Yamaha TW clone engine NC250 engine etc
You’ll do fine with that! |
Quote:
|
So does this mean the cam swap is about to began??:clap:
|
Shouldn't be necessary for that, perhaps the crank is getting swapped out, or maybe an EFI kit?
|
Quote:
Quote:
|
All times are GMT -4. The time now is 05:41 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.