Hawk Seat Height
I'm looking to get a little more height out my hawk(even just 1 or 2 more inches of seat height) and to have the seat be a bit more flat rather than slightly angled towards the head of the bike. What do you guys think about extending the front forks a little more than they're set to be, just to milk a couple more inches out of the bike?
Thanks y'all |
Extending the front forks increases rake, which improves high speed stability at the cost of slowing low-speed steering. Raising the rear has the opposite effect.
That said, the forks should be flush with the top of the upper triple. Are they? |
I'm sorry, what do you mean by flush? They are even and maybe a half inch higher than the triple tree.
Thanks Weldangrind |
It sounds like you're saying that the forks are sticking up through the upper triple by 1/2". Is that right? Can you show us a pic?
|
Will do when I get a chance.
|
1 Attachment(s)
Hey Weldangrind sorry I took so long to get this picture to you but here it is. This is how my forks are set. They are even on both sides.
|
Thanks for the pic. Your fork tubes are flush with the top of the upper triple, so you have no room to extend the current forks; they are as low in the clamps as they can go.
|
:(
|
Quote:
...add handlebar risers ...add an inch or two of foam to the seat jb |
For sure. Thanks jb! Will look into both of those things
|
All times are GMT -4. The time now is 11:02 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.