Delphi MT05 sequence for imperial/metric
 

Is there an ignition key sequence for changing MPH to KPH (imperial/metric) reading for a Delphi MT05 ECU? The bike is a Brixton BX125, had to perform a hard reset of the ECU to clear out a fault code and that switched my clock to miles per hour.

I don't have an OBD2 reader or the right software tools to read/write MCU settings, really hoping there's a sequence for this setting as well.

Not in ecu I’d say? Weird
I don’t recall seeing it in live data
Prob press button on dash then turn key on..

The factory guy says turn on off quickly twice

Will try that. Thanks a lot, really appreciate it!

Many thanks, that worked beautifully.

For clarity to other readers, the full sequence for switching between imperial and metric readings on the dashboard -

1. Turn iginition off for at least 15 seconds
2. Turn ignition on/off two times really quick (half a second or so each cycle)
3. Wait 15 seconds (with ignition off)
4. Turn ignition on, your readings should now be in the new measurement system