ChinaRiders Forums

ChinaRiders Forums (http://www.chinariders.net/index.php)
-   Dual Sport/Enduro (http://www.chinariders.net/forumdisplay.php?f=101)
-   -   Brozz 250 broken clutch bolts (http://www.chinariders.net/showthread.php?t=32908)

Jds1988 06-23-2023 12:56 AM

Brozz 250 broken clutch bolts
 
I am a new owner of a ‘22 Brozz recon and have been doing some upgrades. I just recently attempted to install some upgraded clutch springs and sheared off one of the bolts holding the springs in and I’m not sure how to go about fixing this. My question is should I replace the whole clutch basket or just the screws and where can I get the correct parts? If anyone can help it would be greatly appreciated.

CheapThrills 06-25-2023 04:17 PM

I did the same with my TBR7, I pulled the whole basket out, and using a drill and small drill bit, was able to drill into the bolt, from the front(not the head side) and as the drill bit, well bit into the bolt, it screwed the bolt out.


Once out, I bought new bolts at like a Lowes.



I believe the bolts' torque is measured in-lbs, I just hand tighten them with lock-tite.


It's what I did, hope all goes well.


:D

Jds1988 06-25-2023 07:48 PM

I’ll try that thank you sir

Megadan 06-26-2023 12:24 PM

Quote:

Originally Posted by CheapThrills (Post 396709)
I did the same with my TBR7, I pulled the whole basket out, and using a drill and small drill bit, was able to drill into the bolt, from the front(not the head side) and as the drill bit, well bit into the bolt, it screwed the bolt out.


Once out, I bought new bolts at like a Lowes.



I believe the bolts' torque is measured in-lbs, I just hand tighten them with lock-tite.


It's what I did, hope all goes well.


:D

108 inch lbs for most small Honda engine clutch bolts. Aka 9lb-ft


All times are GMT -4. The time now is 07:11 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.